Tom handlekurv

IBM Emulex 10GbE Virtual Fabric

Forsiden / Datautstyr / Kontrollere / Kontrollere / IBM Emulex 10GbE Virtual Fabric
Du må logge inn for å handle/se priser.
IBM Emulex 10GbE Virtual Fabric Adapter II - BladeCenter  (00Y3266)

IBM Emulex 10GbE Virtual Fabric Adapter II - BladeCenter

Varenr.:
00Y3266
EAN:
883436360326
  • Porter/kontakter Network
  • Eksterne porter Nei
  • Grensesnitt PCI-E
  • Interne porter Ja
  • RAID Nei
Forventet på lager 28.09.2019
Beskrivelse

Emulex 10GbE Virtual Fabric Adapter II for IBM BladeCenter

The Emulex 10 GbE Virtual Fabric Adapter II and Emulex 10 GbE Virtual Fabric Adapter Advanced II are enhancements to the existing IBM BladeCenter Virtual Fabric portfolio. These adapters allow IBM clients to simplify their I/O infrastructure by reducing the number of switches needed inside the chassis. The Emulex 10GbE Virtual Fabric Adapter II is a dual-port 10 Gb Ethernet card that supports 1 Gbps or 10 Gbps traffic, or up to eight virtual NIC devices.

  • Connection to either 1 Gb or 10 Gb data center infrastructure (1 Gb and 10 Gb auto-negotiation)
  • PCI Express 2.0 x8 host interface
  • CFFh form factor, can be combined with a CIOv expansion card on the same blade server
  • It operates either as an 8-port virtual NIC or as a 2-port 1/10 Gb Ethernet adapter: Virtual port bandwidth allocation in 100 Mbps increments
  • Supports up to eight virtual ports
  • Wake On LAN support
  • Full-duplex (FDX) capability
  • Bus-mastering support
  • Direct memory access (DMA) support
  • Preboot Execution Environment (PXE) support
  • IPv4/IPv6 TCP, UDP checksum offload Large send offload (LSO)
  • Large receive offload
  • Receive side scaling (RSS)
  • IPv4 TCP Chimney Offload
  • TCP Segmentation Offload
  • VLAN insertion and extraction
  • Jumbo frames up to 9000 bytes
  • Load balancing and failover support including adapter fault tolerance (AFT), switch fault tolerance (SFT), adaptive load balancing (ALB), teaming support, and IEEE 802.3ad
  • Enhanced Ethernet (draft) Enhanced Transmission Selection (ETS) (P802.1Qaz)
  • Priority-based Flow Control (PFC) (P802.1Qbb)
  • Data Center Bridging Capabilities eXchange Protocol, CIN-DCBX and CEE-DCBX (P802.1Qaz)
  • The Emulex Virtual Fabric Adapter Advanced II provides FCoE and iSCSI hardware initiator support.
  • Supports Serial over LAN (SoL) and concurrent KVM (cKVM)
  • Supports two vNIC modes: IBM Virtual Fabric Mode and Switch Independent Mode.

Selv om vi gjør vårt beste for å gi relevant informasjon, så er bildene kun for å gi et generelt inntrykk, og selve varen er ikke nødvendigvis akkurat slik som avbildet. Dersom det er forskjeller mellom produktoverskrift, beskrivelse og bilde, så er det produktoverskriften som gjelder (f.eks. PCer kommer ikke nødvendigvis med skjerm selv om bildet viser det). Hvis noe er uklart, vennligst send epost til kundestøtte før du bestiller. Vi tar forbehold om trykkfeil og endring av priser og spesifikasjoner uten varsel.